*If you wish to contribute or participate in the discussions about articles you are invited to join Navipedia as a registered user*

# GNSS Basic Observables

Fundamentals | |
---|---|

Title | GNSS Basic Observables |

Author(s) | J. Sanz Subirana, J.M. Juan Zornoza and M. Hernández-Pajares, Technical University of Catalonia, Spain. |

Level | Basic |

Year of Publication | 2011 |

The basic GNSS observable is the travelling time of the signal to propagate from the phase centre of the satellite antenna (at the emission time) to the phase centre of the receiver (at the reception time). This value multiplied by the speed of light gives us the *apparent*^{[footnotes 1]} range between them.

As commented in article GNSS signal, the GNSS signals contain ranging codes to allow the users to compute the travelling time . Indeed, the receiver determines correlating the received code () from the satellite with a replica of it generated in the receiver, so this replica is moved in time () until the maximum correlation is obtained (see figure 1).

This measurement is what we know as *pseudorange* or *pseudodistance* and it is an "apparent range" between the satellite and the receiver that does not match with its geometric distance due to, among other factors, synchronism errors between receiver and satellite clocks. Taking explicitly into account possible synchronism errors between these clocks, the travelling time between transmission and reception is obtained as a difference of times measured in two different clocks or time scales: the satellite () and the receiver (). Thence, considering a reference time scale , which we will call GNSS (i.e., GPS, GLONASS, Galileo), the pseudorange measurement for satellite and receiver may be expressed as:

Where:

- is the speed of light in a vacuum.
- is the time of signal reception, measured in the time scale given by the clock of receiver .
- is the time of signal transmission, measured in the time scale given by the satellite clock .

The Pseudorange measurement obtained by the receiver using this procedure includes, besides geometric range between the receiver and the satellite and clock synchronism errors, other terms due to signal propagation through the atmosphere (ionosphere and troposphere), relativistic effects, instrumental delays (of satellite and receiver), multipath and receiver noise (see GNSS Measurements Modelling). Taking explicitly into account all these terms, the previous equation can be rewritten as follows, where represents any GNSS code measurement at frequency (from GPS, GLONASS, Galileo, etc.):

- is the geometric range between the satellite and receiver antenna phase centres at emission and reception time, respectively (see article Geometric Range Modelling). Note: The Antenna Phase Centre (APC) is frequency dependent, but we neglect this effect here for simplicity (see article Antenna Phase Centre).

- and are the receiver and satellite clock offsets from the GNSS time scale, including the relativistic satellite clock correction (see Clock Modelling).

- is the tropospheric delay, which is non-dispersive (see Tropospheric Delay).

- is a frequency-dependent ionospheric delay term, where is the conversion factor between the integrated electron density along the ray path , and the signal delay at frequency . That is, , where the frequency is in and .(See article Ionospheric Delay).

- and are the receiver and satellite instrumental delays, which are dependent on the code and frequency (see articles Combination of GNSS Measurements and Instrumental Delay).

- represents the effect of multipath, also depending on the code and frequency, and is the receiver noise (see article GNSS Measurement features and noise).

Besides the code, the carrier phase itself is also used to obtain a measure of the apparent distance between satellite and receiver. These carrier phase measurements are much more precise than the code measurements (typically two orders of magnitude more precise), but they are ambiguous by an unknown integer number of wavelengths ). Indeed, this ambiguity changes arbitrarily every time the receiver loss the lock on the signal, producing jumps or range discontinuities.

The carrier phase measurements () can be modeled as:

where, besides the terms seen in equation (2), it includes the wind-up () due to the circular polarisation of the electromagnetic signal ^{[footnotes 2]} and the integer ambiguity (see GNSS Measurement features and noise).

The terms and are frequency dependent and corresponds to carrier phase instrumental delays (see Undifferenced Ambiguity Fixing) associated to the receiver and satellite, respectively. The and terms are the carrier phase multipath and noise.

Notice that the ionospheric term has opposite sign for code and phase. This means that the ionosphere produces an advance of the carrier phase measurement equal to the delay on the code measurements (see Ionospheric Delay).

## Notes

- ^ It is called apparent, or pseudo-range, to distinguish it from the true range, since different effects make them to differ.
- ^ A rotation of 360 degrees of the receiver antenna, keeping its position fixed, introduces a variation of one wavelength in the phase-obtained measurement of apparent distance between the receiver and the satellite (see article Carrier Phase Wind-up Effect).